A value must be entered. If unknown when developing
scheme, you must review output prior to installation.
Maximum Number of Users: *
Maximum number of user 4. This figure will be used
to calculate the maximum load within 20%
Roof/Membrane Manufacturer
Roof Drawings *
Upload a PDF file.
Please supply elevation plan so that we can assess correctly
* Mandatory Field
Roof Type *
Roof Material *
Barrel Roof (curvature in degrees):
Crown Centres (mm):
Gauge/Sheet Thickness (mm):
Roof Angle (degrees)
Maximum supported pitch is 15 degrees:
Roof Material *
Built up on site (BUOS)
Standing Seam
Other
Roof Material *
Insulation Depth
Tapered Insulation
Uniform Insulation
Roof Substrate
Metal
Timber
Concrete
Please use a laptop/desktop to edit your drawing.
Processing..
Please wait whilst we prepare
your uploaded drawing.
This may take up to 60 seconds depending upon the original size.
Fall Protection Visualizer (FPV) - Layout Editor
To set the drawing scale, use the mouse to plot two points against a scale on the drawing. Try to make this as accurate as possible by using the zoom in and zoom out buttons. Once you have plotted your two points, enter the corresponding distance into the input field and click on the 'Save Scale' button. If there are no dimensions on the drawing, multiply the scale ration of the drawing with the border scale and enter this into the input field. To reset where you have plotted your points, click on the 'Reset Scale' button.
Post Module:
Edge Inset (mm):
System Identifier:
Post Actions:
Edge Perimeter:
m
Distance between two markers [mm]:
×
Fall Protection Visualizer
Your project reference is: {id}
Please find attached your project specific report including component list and
layout design.